冷卻塔風機效率若何提高

1、橫流式冷卻塔宜控制填料頂部至風機吸入段下緣的高度等于或大于風機直徑的0、2倍。2、逆流式冷卻塔填料頂面至風筒進口之間氣流收縮段的高度應符合下列規定：a當塔頂蓋板為平頂時，從填料頂面算起的氣流收縮段頂角宜小于90°;當平頂蓋板下設有導流圈傘時，從收水器頂面算起的氣流收縮段頂角可采用90°～110°。b當塔頂蓋板自收水器以上為收縮型時，收縮段蓋板的頂角宜采用90°～110°。3、橫流式冷卻塔的淋水填料從頂部至底部應有向塔的垂直中軸線的收縮傾角。點滴式淋水填料的收縮傾角宜為9°～11°;薄膜式淋水填料的收縮傾角宜為5°～6°。4、雙側進風的逆流式冷卻塔宜設中部擋風隔板，隔板上緣距填料支撐梁底200～300mm，下緣伸入塔的集水池水面以下。5、橫流式冷卻塔宜設置防止空氣從填料底至水面間短路流通的措施。

玻璃鋼儲罐維護方法

1、進入罐內維護，應先關閉所有進料閥門，放空并清洗罐體，經檢測確認罐內無有毒氣體，不缺氧時才能進入貯罐，進入罐內應穿軟底鞋，綁上安全帶并將安全帶另一端系于罐頂，注意罐內通風。進入罐內操作，必須有人員在罐外監控下進行。要防止工器具撞傷罐壁，使用梯子、金屬件等于罐壁接觸部分要加軟質墊，保護內壁不被劃裂、挫傷。2、貯罐的外爬梯、護籠、護欄在攀爬前應仔細檢查是否安全可靠，有異常情況嚴禁攀爬使用。3、維修時不可在罐頂隨意加載，也不準在接管上施加外力。4、戶外使用貯罐使用多年后會因外表層老化，造成樹脂層剝落或纖維外露。建議每二、三年應在罐外表面涂刷油漆或樹脂，以防老化，延長使用壽命。